Oki ES9476 MFP Hardware Troubleshooting Manual page 92

2.WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
Problem Description
Sheets are not aligned
when exiting.
The message indicating no
paper does not disappear
even after paper is placed in
the tray.
92 When You Think Something Is Wrong With the Equipment
Cause
Sheets are not placed in the tray
with correct side up for this
equipment.
The type of paper
corresponding to that being
used has not been set.
Sheets placed in the tray are not
aligned.
The side and end guides do not
match the paper size in the tray.
The amount of paper placed in
the Large Capacity Feeder is too
small.
The paper is jammed at the end
of the tray.
There is something other than
paper in the tray.
Corrective Action
Check the printing side of the sheets and place
them correctly. Information about the printing side
may be given on the wrapping paper of the sheets.
If you cannot find which side is the printing side, try
printing on both sides to see if the sheets are
aligned when exiting.
Check that the set paper type corresponds to the
paper in use.
For details, refer to Chapter 1 of the Paper
Preparation Guide.
Remove the sheets from the tray, align them, and
replace them.
Adjust the side and end guides to match the paper
size.
Place more than 10 sheets of paper in the Large
Capacity Feeder.
Pull out the tray and remove any jammed paper.
Do not put anything but paper in the tray.