1.TROUBLESHOOTING FOR THE HARDWARE
5
Open the cover of the Hole Punch Unit when it is installed.
6
Turn the knob shown in the following figures to send the paper, and then remove the jammed
paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same time.
When the Hole Punch Unit is not installed
Be sure to turn the knob to the direction indicated by the arrow to remove the jammed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
Some jammed paper may get inside of the Saddle Stitch unit depending on the location where the jamming
occurs. In this case, follow step 7.
When the Hole Punch Unit is installed
Clearing a Paper Jam 47