Camus Hydronics DMH 081 Installation, Operation And Service Manual page 38

Run Time Display
Figure 58: Run Time
From SYSTEM display;
1) Use [NEXT] to view RUN TIME display
Table 32: Run Time Display Readout
DISPLAY
READOUT
Total Run
RUN
Time Since
TIME
Installation
Fan Diagnostics Display
Figure 59: Fan Diagnostics
From RUN TIME display;
1) Use [NEXT] to view FAN DIAGNOSTIC display.
Table 33: Fan Diagnostic Display Readout
DISPLAY
READOUT
Min.
FAN Max.
DIAGNOSTICS
(RPM)
Ign.
Actual
To move back to the previous screen at anytime, press the
[PREVIOUS] button.
DESCRIPTION
Monitors the amount of
operational time since the
DynaMax was installed. The
timer starts counting as soon
as it receives a flame signal to
the time the flame signal
disappears
DESCRIPTION
Programmed Minimum
Fan Speed
Programmed Maximum
Fan Speed
Programmed Ignition Fan
Speed
Actual Fan Speed
updated in real-time
Display Options Display
Figure 60: Display Options Display
From MENU display;
1) Use [PREVIOUS]/[NEXT] button to select 'Display
Options'.
2) Press ENTER
Language Display
Figure 61: Language Display
1) Use [UP]/[DOWN] buttons to select preferred
language.
2) Press [ENTER] to confirm.
Date and Time Display
Figure 62: Date and Time Display
From LANGUAGE display;
1) Use [NEXT] to view DATE AND TIME display
2) Use [UP]/[DOWN] and the cursor arrow will point to
either the Day, Date or Time
3) Press [ENTER] to change a parameter. The
parameter will begin to flash
4) Use [UP]/[DOWN] to change parameter value.
5) Press [ENTER] to confirm.
Units Display
Figure 63: Units Display
From DATE AND TIME display;
1) Use [NEXT] to view UNITS display
2) Use [UP]/[DOWN] to select the desired unit of
measurement
3) Press [ENTER] to confirm.
To move back to the previous screen at anytime, press the
[PREVIOUS] button. When no action is detected for 30
seconds, the screen will default back to the Temperature and
Status Display.
34