JVC CH-X470RF Service Manual page 6

CH-X470RF
Removing the fittings (See Fig.10)
1. Remove the fixing screw F.
2. Unhook the two catches a on the top edge of the
fitting, then unhook the two catches b at the left /
right bottom edges.
Removing the main PCB assembly
1. Remove the power IC fixing screw G.
2. Remove the four screws H securing the main board
assembly.
3. Disconnect position motor wire connector CN504
from the main board assembly.
4. Disconnect sensor board assembly wire connector
CN601 from the main board assembly.
5. Remove the flexible ribbon wire from CN502 on the
traverse mechanism board assembly.
When reinstalling the board boards, refer to the
reassembling procedures for protecting switches, etc.
1-6
Catches b
(See Fig.11)
CN502
Catches a
Fitting
F
Fig. 10
CN601
H
H
Main board
CN504
Fig. 11
H
G