Table of Contents
Advertisement
Mounting the sensor board assembly
1.
Attach the longer spring to the white resin, and
attach the shorter spring temporarily to the sensor
assembly bracket.
2.
Mount the sensor assembly so that the shaft of the
lift arm is inserted into the longer hole on the white
resin located on the back of the sensor board
assembly.
3.
Attach the shorter spring to the hook of the lift arm.
Mounting the main PC board assembly
1.
Rotate the third gear clockwise until section x of the
front slider and the third hole from the right are lined
up.
(Be sure to set properly.
switches on the board assembly may be damaged.)
2.
After they are correctly positioned, mount the main
board assembly.
(See Fig.47)
(See Fig.48)
If incorrectly set, the
I
Attach
temporarily
Shorter spring
Longer spring
Fig. 47
Position so that the slider hole and
third hole from the right are lined up
Fig. 48
CH-X470RF
Sensor assembly fixing screws
I
Shorter
spring
x
1-17
Advertisement
Table of Contents
