Removing The Top Cover - JVC CH-X470RF Service Manual

Removing the top cover

1. Remove the four damper bracket fixing screws C to
remove the damper brackets.
2. Pull out the dampers, being careful not to damage
them.
When reattaching a damper, insert your finger to
push out the center of the damper to mount it on the
damper shaft, as shown in Fig. 6-1.
3. Turn the damper spring bracket toward the top at a
right angle as shown in Fig. 7, then push down the
lower side of the damper spring bracket to lift it off.
4. Remove the three fixing screws D and E on the DIN
jack board assembly.
5. Lift the changer unit upward.
6. Remove the damper springs from the mechanism
chassis if required.
diagram below.
Apply alcohol to the shaft then immediately
attach the damper. (After attaching, check
that the shaft is correctly inserted.)
Damper shaft
Damper
Damper spring
Mechanism
Silver
(mechanism side)
How to attach the damper springs
(See Fig.5 to 9)
To reassemble, refer to the
Push out with your finger
before attaching
Fig. 6-1
Lift the changer unit upward
Fig. 8
Damper spring
Chassis
Black
(magazine side)
Fig. 8-1
Damper
Damper bracket
Fig. 5
Damper
Damper bracket
C
C
Damper bracket
Fig. 6
Turn to the top position (at a right angle),
then push down to lift off.
Damper spring bracket
Fig. 7
Remove the flexible ribbon
wire if required
DIN jack board
Fig. 9
CH-X470RF
Damper
Damper bracket
C
C
Damper
E
E
D
1-5