JVC CH-X470RF Service Manual page 16

CH-X470RF
Mounting the front slider and rear slider
1. Position the unit with the rear side facing down, then
rotate the third gear in the direction of the arrow
(clockwise) until the lift arm comes to the position at
which the holes are exposed, as shown in Fig. 45-1.
2. Mount the front slider from the top.
Rotate the third gear counterclockwise until the hole
of the slider is lined up with the right hole of the stud,
as shown in Fig. 45-2.
3. Mount the E-washer on the shaft.
4. Position the unit with the front side facing down, then
mount the rear slider. Check that the u, v and w
positions are correctly mounted as shown in Fig. 46.
5. Rotate the third gear in the direction of the arrow
(counterclockwise) until the lifter unit is at the top
position.
1-16
(See Fig.45 and 46)
Front slider
Check after mounting
Rotate the third gear
to move the slider
Fig. 45-1
Rotate until the
holes are lined up
u
Fig. 46
Stud
E-Washer
Position so
that the stud
and right hole
are lined up
Fig. 45-2
Fig. 45
Set so the holes
are exposed
v
w
Rotate the third gear
to move the slider