Inserting Batteries In Cordless Telephone; Putting Cordless Telephone In Operation - Philips PPF 695 User Manual

Inserting batteries in cordless tel-
ephone
1 Insert the new batteries in the battery compartment
with the positive and negative poles as shown in the pic-
ture in the battery compartment.
EN
Never use non-rechargeable batteries in the
cordless telephone. Follow the specifications in
the technical data.
2 Place the cover on the battery compartment and slide it
upward until it snaps into place.
3 Place the cordless telephone into the charging station.
Never place the cordless telephone into the charg-
ing station without batteries.
Leave the cordless telephone in the charging sta-
tion for at least twelve hours. The batteries will
heat up slightly during charging; this is not dan-
gerous.
Putting cordless telephone in op-
eration
Switching on cordless telephone
Press the green " button for at least two seconds for
switching on your cordless telephone.
Configuring the Cordless Telephone
Normally your cordless telephone is registered with your
device in the factory. In the starting mode, press OK. The
display shows on which base unit and with which number
the cordless telephone is registered.
Unregistered cordless telephones
If you acquired a model with several cordless tele-
phones, only one cordless telephone is registered
with your device in the factory. Insert the batteries as
described above and register the cordless telephones
with your device (also see Chapter "Telephone Con-
nections and Additional Devices", page 43).
12 Philips PPF 685 · 695