Checking The Firmware Version; Using Service Codes; Power Cycling - Philips PPF 695 User Manual

Philips fax machine user manual
Table of Contents

Advertisement

Never use non-rechargeable batteries in the
cordless telephone. Follow the specifications in
the technical data.
EN
5 Place the cover on the battery compartment and slide it
upward until it snaps into place.
6 Place the cordless telephone into the charging station.
Never place the cordless telephone into the charg-
ing station without batteries.
Leave the cordless telephone in the charging sta-
tion for at least twelve hours. The batteries will
heat up slightly during charging; this is not dan-
gerous.

Checking the Firmware Version

1 Press OK, 47 and OK.
2 The model designation and the configured country ap-
pear on the display.
3 Confirm with OK.
4 The information on the firmware version of the device
is displayed.
5 Confirm with OK.
General information
The time and date flash on the display.
Problems when faxing or printing
Faxes sent are of poor quality.
The device produces black lines when sending or printing. Clean the scanner and the document feed slot.
50

Using Service Codes

The service codes delete all the changed settings and your
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than ex-
pected.
Using Service Codes
Only use the service codes if this is absolutely neces-
sary. Some service codes also delete saved messages
and telephone book entries.
1 Press OK, 45 and OK.
2 Enter a service code:
7117—Deletes all changed settings and saved
data. The device is reset to factory settings and the initial
installation process is started.
7140—Deletes all changed settings. Saved data
and telephone book entries remain intact.
7227—Deletes saved faxes, when there are
problems with printing.
3 Confirm with OK.
4 Using [ select SURE: YES .
5 Confirm with OK.
If you have entered the incorrect code, you can
cancel the entry with SURE: NO .

Power Cycling

If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1 Pull out the power plug.
2 Wait at least ten seconds, then plug the power plug
back into the socket.
3 If the error occurs again, please contact our technical
customer service or your retailer. Follow the instruc-
tions on the display and on the error report.
You must check the time and date after a short power fail-
ure. Confirm using OK.
Change the resolution from RESOL.: STANDARD to
RESOL.: FINE or RESOL.: PHOTO .
Change the contrast.
Clean the scanner and the document feed slot.
Test the device by making a copy of the document. If the
device is in order, the fax machine of the recipient is defec-
tive.
Philips PPF 685 · 695

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents