Range Test - Tactic TTX650 Instruction Manual

2. Pull the TTX404/600 trainer switch and hold it in this position and turn the power switch on.
3. Move the student's transmitter to within 3 feet of the teacher's transmitter, turn the power switch on and set
the RF OUTPUT to ON.
4. The TTX404/600 LED should flash three times and then stay on to indicate the bind was complete. Release
the trainer switch.
5. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx power on and make sure
only those channels selected for transfer to the student are transferred when the TTX650 trainer switch is
deflected. Ensure the teacher can regain control of all channels when the trainer switch is released.
6. Perform a complete range check before flight.
7. When the training session has ended, with the model safely landed and power removed from the model
simply turn the power switch for both transmitters to the OFF position. This will terminate the wireless link
between both transmitters.
Teacher and student's radio: TTX650
1. Bind the teacher's radio to the Rx.
2. In the teacher's TRAINER screen described on page xx select which channels to NOT be transferred to the
student while training, and select a switch to control the training function. Then turn the teacher's Tx off.
3. Move the student's transmitter to within 3 feet of the teacher's transmitter.
4. Pull the teacher's trainer switch and turn the power switch on. The "searching" screen should show.
5. Turn the student's radio on, and set the RF OUTPUT to ON.
6. The TTX650's "searching" screen should disappear. The teacher can release the TTX650 trainer switch. If the
TTX650 doesn't identify the signal from the student's radio a "NO SIGNAL" message will show.
7. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx power on and make sure
only those channels selected for transfer to the student are transferred when the TTX650 trainer switch is
deflected. Ensure the teacher can regain control of all channels when the trainer switch is released.
8. Perform a complete range check before flight.
9. When the training session has ended, with the model safely landed and power removed from the model
simply turn the power switch for both transmitters to the OFF position. This will terminate the wireless link
between both transmitters.
RANGE TEST: Before each flight make sure to check the operating range of the Tx / Rx set. The TTX650 includes
a function that automatically reduces its output power to prevent having to walk a long distance to check the
range.
24