Aileron Mixer; Elevator Mixer - Tactic TTX650 Instruction Manual

of one aileron is at a lower or higher rate than the opposite aileron. Certain applications may require a reduction
in the aileron differential rate when an airbrake is applied. This feature is useful for glider and/or sailplane
applications which use other settings to achieve "butterfly" or "crow" functionality.
Enter the DIFFERENTIAL function. There are two ways to control the mix. One is to make the mix be active at all
times. Another is to control the mix with an otherwise unused switch.
To make
AILE DIFFERENTIAL
the differential rate percent and press ↑+ or ↓- to find the desired value. Press ENTER when finished.
To control the mix with a switch, move the cursor to the CTRL line and press ENTER. Deflect the switch that will
control the mix. The screen will show the functional assignments for each position of the switch as described
previously. Press ESC to confirm the switch selection. The display will now show the different switch positions
(SP.0, SP.1, SP.2). A different rate can be set for each switch position.
Deflect the switch to one position, and note the cursor on-screen will move automatically to the rate for that
position. Adjust that rate as desired. Deflect the switch to the remaining positions and repeat. To remove a
switch which might have been assigned previously, highlight the switch selection in the CTRL line and press CLEAR.
Press ESC once all mixing values are set to return to the FUNCTION menu screen.
AILERON FLAP ADJUST: This
function is for setting the maximum
deflection angle of the aileron
and/or flap servos for takeoff and
landing purposes, which can be
controlled by a switch. This is only
available for 2AI and 2AIL1FL wing types. Ailerons-only can be set if the selected wing type is 2 ailerons (2AI).
Aileron and flap selections will show if the selected wing type is 2 ailerons + 1 flap.
Enter the AIL FLAP ADJUST function. Determine set the percentage(s) as needed.
AILERON MIXER: The aileron
channel can be mixed to the rudder
channel, which can be useful with
certain wing/airplane types.
To make this AILE RUDD mix active at all times do NOT assign a switch at the CTRL line. Adjust the mixture
percentage and press ENTER.
On/off control of this mix can be assigned to a switch. Set the mix rates as desired for each switch position. Press
ESC when finished.
ELEVATOR MIXER: Not available
for the 1AI wing type selection. The
elevator channel can be mixed to the
ailerons or flaps depending on the
wing type.
active at all times do NOT assign a switch at the CTRL line. Press ENTER to highlight
Tail type
Normal
Delta
Tail type
Normal
Delta
Tail type
Normal
Delta
AIL FLAP ADJUST
Mixing 1 Ail 1 Ail, 1 Flap
Ail
Flap
Ail
Flap
AILERON > RUDDER
Mixing 1 Ail 1 Ail, 1 Flap
Ail > Rudd X
Ail > Rudd

ELEVATOR MIXER

Mixing 1 Ail 1 Ail, 1 Flap
Elev > Ail
Elev > Flap
Elev > Ail
Elev > Flap
2 Ail 2 Ail, 1 Flap
X X
X
X
2 Ail 2 Ail, 1 Flap
X X X
X X
2 Ail 2 Ail, 1 Flap
X X
X X
X
X
15