Installation Layout; Additional Accessories; Preparatory Steps - V2 Vulcan Manual

INSTALLATION LAYOUT

3
C
COMPONENTS
1 Motor
Transmitter
2
Control unit
3
Photocells
4
Flashing light
5
LENGTH OF THE CABLE
Power supply 230V
Photocells (TX)
Key switch
Photocells (RX)
Flashing light
Antenna (integrated into the flashing light)

PREPARATORY STEPS

The new series of actuadors VULCAN, has been devised to serve
gates up to 800 Kg with leaf up to 3 meters wide (look at the
table technical data). Before proceeding with the installation,
please make sure that your gate opens and closes freely, and that:
• Hinges and pins are in optimum condition and properly
greased.
• No obstacles are within the moving area.
• There is no friction with the ground or between the leaves.
• The stop limit switch must be installed inside the foundation
box (see paragraph about Installation of the stop limit switches)
D
5
1

ADDITIONAL ACCESSORIES

A Key switch
Pillar photocells
B
Pillar-mounted digital radio switch
C
Safety edges
D
< 10 metres
3G x 1,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm
2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174
- 9 -
4
1
2
from 10 to 20 metres
3G x 1,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm
2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174
A
B
from 20 to 30 metres
3G x 2,5 mm
2
2 x 0,5 mm
2
4 x 0,5 mm
2
2 x 0,5 mm 2
2 x 1,5 mm 2
RG174