Table of Contents
Advertisement
3.5 - MOTOR OVERRIDING SYSTEM
In case of absence of current, the gate can be released by
operating on the motor:
1. Open the hatch of the lock J in front of the motor
2. Insert the key K in the lock and turn clockwise to open the
hatch of the release on the side
3. Insert the key L into the hole and turn clockwise until reached
the limit switch
To restore the automation, proceed as follows:
1. Turn the key L anticlockwise until reached the limit switch,
then draw it out
2. Turn the key K anticlockwise closing the hatch of the lock,
then draw it out
3. Close the lock with the hatch J
3.6 - INSTALLATION LAYOUT
FORTECO actuator
Rack
Flashing light with built-in antenna
Photocells
Key switch
Transmitter
Pillar photocells
Pillar-mounted digital radio switch
Safety edge (EN 12978)
Power supply cable 3 x 1,5 mm
-
Power supply 2 x 1 mm
2
cable 4 x 0,5 mm
2
(RX) - cable 2 x 0,5 mm
cable 2 x 1 mm
2
-
cable 4 x 0,5 mm
2
(RX) - cable 2 x 0,5 mm
-
-
46
2
(T100°C)
- antenna RG58
2
(TX)
2
(TX)
Advertisement
Table of Contents
