Base Memory; Extended Memory; Total Memory - IWILL VD133 Manual

5.3.6 Video
This field specifies the type of the graphics adapters used by the primary system
monitor.
Options
EGA/VGA (*)
CGA 40
CGA 80
MONO
5.3.7 Halt On
This field determines how the system reacts to errors once detected.
Options
All Errors (*)
No Errors
All, But Keyboard
All, But Diskette
All, But Disk/Key

5.3.8 Base Memory

The POST (Power-On Self Test) determines the amount of base (conventional) memory
installed in the system. The value of the base memory is typically 640K. This field
has no options.

5.3.9 Extended Memory

The BIOS determines how much extended memory is present during the POST. This
is the amount of memory located above 1MB in the processor's memory address map.
This field has no options.

5.3.10 Total Memory

Displays the total memory available in the system
Description
Specifies EGA or VGA adapter
Specifies CGA adapter with 40 column mode
Specifies CGA adapter with 80 column mode
Specifies Monochrome adapter
Description
Each time the BIOS detects a non-fatal error, the system will
stop and display an error message
The system will stop for any errors that are detected
The system will stop for any errors except keyboard error
The system will stop for any errors except diskette error
The system will stop for any errors except diskette and key
board errors
50
Chapter 5 BIOS Setup
VD133 Pro Series