Interface Setup - Dascom 1330 User Manual

Tally Dascom 1330
Paper Setup
BlackMark No, Yes
8.0inch, 8.2inch,
Width
PaperWidth
-20 -19 -18 -17 -16 -15
-14 -13 -12 -11 -10 -9
-8 -7 -6 -5 -4 -3 -2 -1 0
FormLen MicroAdj +1 +2 +3 +4 +5 +6
+7 +8 +9 +10 +11 +12
+13 +14 +15 +16 +17
+18 +19 +20

5.3 Interface Setup

Interface setup
PnP
USB ID
Valid Settings
No: Disables black mark sensor.
Yes: Enables black mark sensor.
When "Yes" and online, pressing the
【
tear-off position.
BlackMark commands: (also see section 5.6)
 1D 0C:
 1C 28 4C 03 00 42 m:
NOTE:
This sensor is an option. Both APS and
BlackMark disappear from this menu if the
sensor is not installed or defective.
8.0inch: The maximum print width is 80
columns of 10cpi PICA characters.
8.2inch: The maximum print width is 82
columns of 10cpi PICA characters.
Paper Width: Sets the detected page width as
print width. Enabling APW is required.
Fine tunes the form-length by n/360" (0.07mm)
based on the default value. (Valid for single
papers and fanfolds.)
Valid Settings
No, Yes
No, Yes
Function
Load/Eject key advances the paper to the
】
Feeds paper to the print position designated
by the black mark. Advance the paper to the
tear-off position after printing.
m = 0: feeds paper to the print position
designated by the black mark.
m = 1: feeds paper to the black mark tear-off
position.
No: Disables plug and play for USB
Yes: Enables plug and play.
No: Disables USB ID.
Yes: Enables USB ID
33
Function