Bi-Directional Alignment - Dascom 1330 User Manual

Tally Dascom 1330
10. The printer reloads the form. By default the form stops 5.5 inches away from the
printer's tear-off blade. Press Next or Back to feed or reverse-feed the paper till the
desired tear-off position is reached. (With the above measured vertical position, the
printer will convert the net paper feeding to the tear-off position relative to the black
mark.) Press OK to confirm the tear-off offset relative to the black mark. Finally, press
Save and Restart to save new settings and terminate the session.

5.7 Bi-directional Alignment

When wiggling vertical grids appears in tabular reports, you should adjust the Bi-directional
Alignment.
The procedures to adjust bi-directional alignment across adjacent line grids:
1. Hold down the
when the Print Head starts to move. After loading paper, the printer prompts the Printer
Settings
Printer Settings
[LF]=Next, [TOP]=Back, [LOAD/EJECT]=OK, [ONLINE]=Exit, [ONLINE]+[LOAD/EJECT]=
Save and restart the printer.
System Setup
2. Press the Next or Back keys to scroll forward or backward the sub-menus till the printer
shows:
Bi-directional Alignment
3. Press OK to go into the Bi-directional Alignment menu. The printer prompts:
[Bidirection Test]
[TOP]=-1, [LF]=+1, [LOAD/EJECT]=OK, [ONLINE]=Back, [ONLINE]+[LOAD/EJECT]=Save
and restart the printer
| | |
| | |
Load/Eject
key while powering on the printer and then release the key
【 】
50
| | | | |
| | | | |
Keys act as proxies for designated functions in the
setting dialog.
Misalignment observed
| | | | |
| | | | |
55
| |
| |