Table of Contents
Advertisement
AXIS
COMMUNICATIONS AB
Author: Sven Svensson
6.2 Repainting of the Dome Module Ass
When repainting the Dome Module ass, the Cover is the part to repaint. Please follow each step
described below. As mentioned earlier, the proper masking before painting is of highest importance in
order to ensure good fit and function when reassembling the camera again. Please note that any
deviation from the steps described below will void the product warranty.
Please note that the original surface finish of the Dome cover ring is PC+ASA. Please use compatible
paint.
6.2.1 Removal of the Dome Module Bracket & the Dome with sealing
Remove the eight screws that hold the Dome module bracket. Remove the Dome Module bracket
together with the Dome with sealing.
Tool: Screwdriver Torx T10
Torque (when refitting): 0,25 Nm
Dome Module bracket)
Screws (8x)
Dome with Sealing
Built-in washer on Dome Module Bracket (4x)
When refitting, Please note:
1) Please note the maximum torque of 0,25Nm.
2) The screws are self threading in the plastic. It is important that the screws thread enter the plastic in
the same position as in the original mounting. Turn the screws anti-clockvise to get the feeling where
the original thread start.
66583
MANUAL RE-PAINT INST AXIS P551X/-E
- 18 -
REV: 2
DATE: 2016-04-07
PAGE:
18(23)
Advertisement
Table of Contents
