Position Weather Station; Replace Wind Cups; Factory Reset/Clear Memory - La Crosse Technology 327-1417 Instructional Manual

Position Weather Station

• Pull out the stand and place on a flat surface.
• Or use the two hanging holes on the back to mount on the wall, near an outlet for
constant backlight.
1. Choose a location 6 feet or more away from electronics such as cordless phones,
gaming systems, televisions, microwaves, routers, etc.
2. Place within range of the outdoor sensors (330 ft, 100m open air).
3. Obstacles such as walls, windows, stucco, concrete, and large metal objects can
reduce the range.
4. For best WWVB reception, orientate the weather station with the front or back of the
station facing Ft. Collins, Colorado.

Replace Wind Cups

1. Loosen the screw
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit snugly on the flat side of the metal stem on
the wind sensor.

Factory Reset/Clear Memory

1. Hold down both the LIGHT and ALERTS button together for 5 second. This will clear
all recorded weather data and reset the station's settings back to default
2. The weather station will fully populate, clear all records, then return to a normal
display and search for outdoor sensors.
3. While searching for the outdoor sensors the Wind Speed, and Outdoor
Temperature/Humidity will show dashes.
4. Once connected to the outdoor sensors (allow 3 minutes) the Wind Speed, and
Temperature/Humidity will show current readings.
5. In the absence of wind this reading will show 0.00.
Dashes = Not connected to sensor
0 or current readings = Connected to sensor.
327-1417
Flat Side Of
Stem Up
Color Wind Speed Weather Station
Insert and Attach
Flat End up
Page | 15
Back
to
Top