Recording Custom Setup Values - HP ProLiant DL160 G5p Software Configuration Manual

It is recommended that you check this screen during the initial system setup and each time you install,
remove, or upgrade accessories.
You first need to enable the display of the diagnostic screen during bootup. Follow the steps below.
To view the boot-time diagnostic screen:
In the Main menu screen, select Boot Options.
1.
Select the BIOS Summary Screen field.
2.
Press the plus (+) or minus (-) key to set the field to Enabled.
3.
Presses F10 to save the changes you made and close the Setup Utility.
4.
Reboot the server.
5.
The BIOS Summary Screen is displayed briefly at the end of POST.
Figure 27 BIOS Summary Screen
Press the Pause/Break key to continue displaying the screen until another key is pressed.
6.
Press any key to continue with the system bootup.
7.

Recording custom Setup values

Write down the settings from the Setup Utility and keep them in a safe place. If the custom values ever
need restoring (after clearing CMOS, for example), you must run the Setup Utility and enter these
custom settings again. Having a record of these custom settings makes this much easier.
System BIOS configuration 36