Annex C. Aba Tk2 Interface - Promag Mifare DESFire User Manual

PROMAG

ANNEX C. ABA TK2 Interface

The timing for Card Present, Clock (Strobe) and Data, example as below:
/CARD PRESENT
/DATA
/STROBE
(CLOCK)
DATA
The data signal is valid while the clock is low. If the Data signal is high, the bit
is a zero. If the Data signal is low, the bit is a one.
CLOCK (STROBE)
The Clock signal indicates when Data is valid. It is recommended that Data be loaded
by the user with the leading edge (negative) of the Strobe.
CARD PRESENT
Card Present will go low after flux reversals from the Reader. Card Present will return
high after the last flux reversal.
Connect the ABA TK2 wires, example as below:
DF700
Leading Zero
0 0 0 . . . 0
Bit Time 40IPS (min:280us, typ:330us, max:480us)
7.5~24VDC
(Red)
Card Present (Orange)
Clock (White)
Data (Green)
(Black)
GND
Optional: External LED/Buzzer Control (Brown)
Data
1 1 0 1 0 0
STROBE Width Approximately 25~50% Of Bit Time
21
Trailing Zero
1 . . . 0 0
HOST/Terminal
GND
DF7XX
REV.C
0