Assembly - Gold's Gym WHIRLWIND 390 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included tool(s) and a rubber mallet .
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing refers to the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit,
check to see if it has been preassembled.
M6 Locknut M8 Locknut M10 Locknut M8 Split M10 Split
(56)–4 (64)–2 Washer (72)–4 Washer (54)–9
(66)–4
M4 x 5mm
M4 x 16mm
M6 x 38mm Button
Patch Screw
Screw (77)–4
Bolt (57)–4
Push Nut
(70)–1
(78)–2
M10 x 17mm Patch M10 x 22mm Patch
M10 x 75mm Carriage Bolt (65)–2
Screw (55)–3 Screw (4)–6
5