Gold's Gym WHIRLWIND 390 User Manual page 10

11. Remove the 1/2" Pedal Nut (68) from the shaft
of one of the Pedals (23). See the lower draw-
ing. Make sure that there is a Pedal Spring
(42), a Blue Washer (71), a Pedal Bushing (43),
a Black Pedal Washer (79), and a Pedal Spacer
(44) on the shaft of the Pedal. In addition, make
sure that the Pedal Bushing is oriented as
shown.
Firmly tighten the shaft of the Pedal (23) clock-
wise into the right Crank Arm (26). Then, tighten
the 1/2" Pedal Nut (68) onto the shaft.
Attach the other Pedal (not shown) in the
same way. Firmly tighten the Pedal counter-
clockwise into the left Crank Arm (not
shown).
12. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
11
68
68
44
79
43
71
10
23
26
23
42