Gold's Gym WHIRLWIND 390 User Manual page 7

4. Attach the Seat (20) to the Seat Post (6) with
four M8 Locknuts (66) and four M8 Split
Washers (72). Note: The Locknuts and Split
Washers may be preattached to the under-
side of the Seat.
5. Tip: To avoid pinching the Reed Switch Wire
(31), position it as shown in the inset draw-
ing.
Apply a small amount of the included grease to
the Handlebar Axle (33). Insert the Handlebar
Axle into the Frame (1) and center it. Tip: It
may be helpful to use a rubber mallet to
insert the Handlebar Axle.
6. While another person holds the Upright (2) near
the Frame (1), connect the Reed Switch Wire
(31) to the Extension Wire (39).
Tip: Do not pinch the Reed Switch Wire (31)
or the Extension Wire (39). Set the Upright (2)
on the Frame (1). Attach the Upright with three
M10 x 17mm Patch Screws (55) and three M10
Split Washers (54).
4
20
6
72
66
5
Do not pinch the Reed
Switch Wire (31)
Grease
33
1
6
55
54
1
7
31
31
Do not pinch
the wires
2
55
54
39
31
1
33