Sensor Fault Delay - Emerson Rosemount 2140 Reference Manual

Configuration
January 2017
2.8.6

Sensor fault delay

When the level detector is operating in Enhanced Mode and detects a fork sensor fault,
Sensor State
The default setting is 5 seconds. It can be set to a value in the range 0 to 3600 seconds.
Note
When the Rosemount 2140 is operating in Normal mode, a fork sensor fault is not detected
and Sensor State continues to indicate a valid state.
To change or view the sensor fault delay
(Field Communicator)
1.
2.
3.
4.
Note
When messages about the loop appear, take appropriate safe action and select "OK".
See "Configuration basics" on page 10
To change or view the sensor fault delay
(AMS Device Manager)
1.
2.
3.
a.
Note
When messages about the loop appear, take appropriate safe action and select "Next >".
See "Configuration basics" on page 10
To change or view the sensor fault delay (LOI)
1.
2.
a.
b. Scroll down (
22
Fast keys
2, 2, 1, 3, 2
(page 82) indicates a fault state after a delay.
From the Home screen, select 2: Configure.
Select 2: Manual Setup > 1: Operation > 3: Sensor.
Select 2: Sensor Fault Delay.
Follow the on-screen instructions to configure the delay.
Right click on the device and select Configure.
Select Manual Setup, and then select the Operation tab.
If changing the delay setting:
Edit the number of seconds at the Sensor Fault Delay field.
Press any LOI button to activate the menu.
(See Table 2-1 on page 8
If changing the mode setting:

Scroll down ( ) and then select EXTENDED MENU ().

) and then select SENSOR ().
for further information.
for further information.
for assistance with using the LOI buttons).
Reference Manual
00809-0100-4140, Rev AA
Configuration