Typical Installations; Mounting Bracket - Graco LDP5 Instructions Manual

Installation

Typical Installations

F . 1 shows a typical hose reel installation. Dispense
IG
valves can also be installed on a console as shown in
Fig. 2.
The typical installation shown in Fig. 1 is only a guide. It
is not a complete system design. Contact your Graco
distributor for assistance in designing a system to suit
your needs.
KEY DESCRIPTION
A Metered dispense valve
B Fluid shut–off valve
C Hose
D Hose reel fluid inlet hose
E Hose reel
A Thermal Relief Kit (not shown) is required. The kit
will vary by pump selected. See Parts, page 28 for a
list of available kits.
B
F . 1
IG
312668ZAA
•
•

Mounting Bracket

Mounting bracket 196471 is available for resting dis-
pense valve on a console. See Fig. 2.
D
E
C
A
ti12081a
F
NOTICE
Do not use this dispense valve on non-Graco con-
soles. The trigger could be inadvertently pressed
while the dispense valve is stowed.
This dispense valve is not designed for in-line
installation. Do not install with a shut-off valve on
the outlet side of the meter which could damage
the meter housing cover.
NOTICE
Do not obstruct the dispense valve trigger and do not
set the unit down resting on its trigger or it might not
stop dispensing.
mounting
bracket
196471
. 2
IG
Installation
ti0274
5