Table of Contents
Advertisement
Installation
Typical Installations
F
. 1 shows a typical hose reel installation. Dispense
IG
valves can also be installed on a console as shown in
Fig. 2.
The typical installation shown in Fig. 1 is only a guide. It
is not a complete system design. Contact your Graco
distributor for assistance in designing a system to suit
your needs.
KEY DESCRIPTION
A
Metered dispense valve
B
Fluid shut–off valve
C
Hose
D
Hose reel fluid inlet hose
E
Hose reel
A Thermal Relief Kit (not shown) is required. The kit
will vary by pump selected. See Parts, page 26 for a
list of available kits.
B
F
. 1
IG
312668D
•
•
Mounting Bracket
Mounting bracket 196471 is available for resting dis-
pense valve on a console. See Fig. 2.
Do not obstruct the dispense valve trigger and do not
set the unit down resting on its trigger or it might not
stop dispensing.
D
E
C
A
ti12081a
F
NOTICE
Do not use this dispense valve on non-Graco con-
soles. The trigger could be inadvertently pressed
while the dispense valve is stowed.
This dispense valve is not designed for in-line
installation. Do not install with a shut-off valve on
the outlet side of the meter which could damage the
meter housing cover.
NOTICE
mounting
bracket
196471
. 2
IG
Installation
ti0274
3
Advertisement
Table of Contents
