Icom IP1000C Instruction Manual page 84

4
ABOUT THE SETTING SCREEN
8. [Transceiver Settings] Menu
M Transceiver Settings (continued)
@7
@8
@9
#0
#1
#2
(This is only an example.)
@7 Provisioning Server ��
@8 SNTP Server �����
@9 Automatic Firmware Updating at Power ON
�����������
Enter an IP Address or Host name of the Provisioning Server for the IP100H,
up to 63 characters.
• When the IP1000C is used as its Provisioning Server, this entry is not
necessary.
Enter the IP Address of the device that is specified as the SNTP server for
the IP100H.
• When the IP1000C is used as its SNTP Server, this entry is not necessary.
Select whether the IP100H will use the Automatic Update function or not.
• Desable
Disables the automatic firmware updating at the IP100H turns ON.
• Enable (without Automatic Reboot)
When tuning ON the IP100H, it confirms the firmware of the IP1000C, and
if there are updating contents, it automatically downloads the firmware.
Then turn OFF the IP100H and turn it ON again, and it starts updating the
firmware.
• Enable (with Automatic Reboot)
When tuning ON the IP100H, it confirms the firmware of the IP1000C, and if
there is an updated firmware version, it automatically downloads it. Then the
IP100H automatically reboots and starts updating the firmware.
You can check the firmware version of the IP100H on the [TOP] menu.
4-48
[Transceiver Settings]–[Transceiver Settings]
# 3 K
(Default: Enable (with Automatic Reboot))
# 4 K