Icom IP1000C Instruction Manual page 65

4
ABOUT THE SETTING SCREEN
8. [Transceiver Settings] Menu
M Transceiver Settings (continued)
q
w
e
r
t
y
u
i
(This is only an example.)
u Server Port Number ��
i Group ��������
o <Apply> �������
!0 <Reset> ��������
Enter the port number that the IP1000C uses to communicate with the
IP100H or IP100FS. (UDP port)
• The set port number (RTP) and the port number +1 (RTCP) are used for the
communication.
• We recommend to use default port number, if it is not problem.
• The default number differs, depending on the [TRX No.] as shown below.
(Default: TRX No. 1 (30000), TRX No. 2 (30002), TRX No. 3 (30004),
TRX No. 4 (30006), • • • • • • • • • • • • • •, TRX No. 100 (30198)
• Setting range: Even numbers between 2 and 65534.
(Some numbers may not be acceptable.)
• Do not set the port number which has already been used by another
connection setting.
Select the group number that the IP100H or IP100FS belongs to. (Default: 1)
• 1 to 100 are selectable.
• Set the Group setting in the [Common Settings] menu, such as ID list,
message or Receive notification tone settings.
Click to apply the entries.
Click to restore the settings.
• You cannot restore after clicking <Apply>.
4-29
[Transceiver Settings]–[Transceiver Registration]
o K ! 0 K