Calibration; Restore Connection To Ibase (Isense Rf Only); Setting The Date And Time - REMEHA iSense Installation And Service Manual

7.6 Calibration

Using Menu > Settings > Users > Calibration lets you adjust
the measured value from the inside and outside sensor. This
can be useful if the measured temperatures do not correspond
to what you are used to.
Imagine that the measured temperature is 0.5°C higher than
what you are used to. You can then enter an adjustment here
of -0.5°C.

7.7 Restore connection to iBase (iSense RF only)

You must restore the connection if the iSense RF or the iBase
is replaced. Proceed as follows:
1. Put the iBase in connection mode. Consult the iBase
manual for this.
2. On the iSense select Menu > Settings > Users >
Connection.
After a few seconds the connection is restored.

7.8 Setting the date and time

Set the following via Menu > Settings > Date/time:
• Set time
• Set date
• Summer time:
- Europe: the iSense automatically switches between
European summer time and winter time.
- Elsewhere: you can set the start and end of summer time
yourself by indicating the month and the week.
The time changes on the Sunday.
- Manual: the iSense does not switch between summer time
and winter time. The time must be changed manually.
16
Remeha iSense