Page 2
IMPORTANT SET UP INFORMATION: Thank you for choosing Marshall and congratulations on the purchase of your British made, all-valve, 30 Watt Astoria Custom AST2C combo or AST2H head. Our goal Before going any further, make sure that 1. Make sure that the speaker or...
FRONT PANEL FUNCTIONS FRONT PANEL FUNCTIONS (CONT.) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - HEAD 4. TREBLE 7. EDGE 1. HI & LO INPUTS Tonal Note: The tonal effect of HI & LO input jack sockets are a feature This controls the level of higher Unlike BASS, MIDDLE and TREBLE, BODY is achieved by a +8dB shelved frequencies.
Page 4
FRONT PANEL FUNCTIONS (CONT.) NOTES Tonal Note 2: The higher the MASTER Technical Note 1: The FX Loop is engaged volume level, the more pronounced the either by the LOOP toggle switch (Rear EDGE function will become. Panel Function #6) or by the supplied footswitch.
8 Ohm speaker cabinet or two 16 supply before attempting to access the Ohm cabinets. fuse compartment. If in doubt consult your Marshall dealer. Note: The AST2C combo’s internal speaker is 8 Ohm.
Page 6
REAR PANEL FUNCTIONS (CONT.) NOTES • 1 x 4 OHM, 2 x 8 OHM: connect a Important Note: Using the SEND single 4 Ohm speaker cabinet or two 8 jack socket to connect to an external Ohm cabinets. power amp does not omit the need for a speaker to be connected to the Important Note: Before unplugging the Astoria Custom’s output stage.
Page 7
Merci d'avoir choisi Marshall et félicitations pour l'achat de votre Astoria Custom utiliser un câble de haut-parleur AST2C Combo ou AST2H Tête à lampes 30 Watt, de fabrication britannique. Avec Avant d'aller plus loin, vérifier que votre adapté. Ne jamais utiliser un câble de l'Astoria Custom, l'objectif était simple : créer un amplificateur mono-canal qui allie...
FONCTIONS DU PANNEAU AVANT FONCTIONS DU PANNEAU AVANT (SUITE) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - TÊTE 1. ENTRÉES HI & LO 6. BASS plus de "rondeur" au son. priorité sur l'interrupteur à bascule Les prises jack d'entrée HI & LO existent BOOST du panneau avant.
Page 9
FONCTIONS DU PANNEAU AVANT (SUITE) FONCTIONS DU PANNEAU AVANT (SUITE) fréquences aiguës entre le déphaseur peut être mis en position MARCHE. et les lampes de puissance. Cela revient Remarque n°4 sur le son : Le volume à utiliser un contrôle de "présence" MASTER est placé...
Page 10
FONCTIONS DU PANNEAU ARRIÈRE FONCTIONS DU PANNEAU ARRIÈRE (SUITE) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - TÊTE 1. ENTRÉE SECTEUR 2. FUSIBLE HT 3. FUSIBLE LT 4. HAUT-PARLEURS Brancher le câble d'alimentation Le FUSIBLE HT saute pour protéger les Le FUSIBLE LT sautera pour protéger Les prises jack du haut-parleur sont secteur à...
Page 11
FONCTIONS DU PANNEAU ARRIÈRE (SUITE) REMARQUES Remarque : Le haut-parleur interne du 7. ENVOI AST2C combo fait 8 Ohm. La prise jack ENVOI raccorde le préampli de l'amplificateur à une entrée • 1 x 4 OHM, 2 x 8 OHM : raccorder un seul caisson haut-parleur 4 Ohm ou FX externe, ou à...
Page 12
Glückwunsch zum Kauf Ihres in Großbritannien gefertigten 30-Watt- Zuerst ist sicherzustellen, dass Lautsprecherbox sicherstellen, dass Vollröhrenverstärkers Astoria Custom AST2C Combo oder AST2H Head. Beim der Verstärker mit dem Stromnetz Sie ein geeignetes Lautsprecherkabel kompatibel ist. Bei Unklarheiten ist ein Astoria Custom war unser Ziel ganz einfach, einen einkanaligen Verstärker mit...
Page 13
FUNKTIONEN VORDERSEITE FUNKTIONEN VORDERSEITE (FORTSETZUNG) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - HEAD 1. HI- & LO-INPUTS 5. MIDDLE 2. GAIN BOOST aktiviert ist. HI- & LO-Input-Klinkenbuchsen sind Mit Hilfe dieses Reglers werden die Mit diesem Regler wird das durch eine Funktion, die auf den meisten den Vorverstärker erzeugte Technischer Hinweis: Wenn der...
Page 14
FUNKTIONEN VORDERSEITE (FORTSETZUNG) FUNKTIONEN VORDERSEITE (FORTSETZUNG) des Verstärkers abhängig von den Verstärker ohne Master-Lautstärke zu bringen. Nach etwa zwei Minuten Einstellungen heller oder tiefer wird. verhält. haben die Röhren die richtige Betriebstemperatur erreicht und der Tonalität 1: Die Funktion EDGE Tonalität 4: Die MASTER-Lautstärke STANDBY-Schalter kann eingeschaltet reduziert hohe Frequenzen zwischen...
Page 15
FUNKTIONEN RÜCKSEITE FUNKTIONEN RÜCKSEITE (FORTSETZUNG) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - HEAD 1. NETZEINGANG 2. HT-SICHERUNG 3. LT-SICHERUNG 4. LAUTSPRECHER Das Netzkabel zuerst in die Falls erforderlich, brennt die HT- Im seltenen Fall eines Bei den Lautsprecherbuchsen NETZEINGANGSBUCHSE am SICHERUNG durch, um die interne Komponentenversagens im Schaltkreis werden die internen und/oder...
Page 16
FUNKTIONEN RÜCKSEITE (FORTSETZUNG) ANMERKUNGEN Hinweis: Der interne Lautsprecher des stellt sicher, dass die Klangintegrität AST2C Combo hat 8 Ohm. beibehalten wird, wenn er sich nicht mehr innerhalb des Schaltkreises • 1 x 4 OHM, 2 x 8 OHM: hier eine befindet.
Gracias por elegir Marshall, enhorabuena por adquirir un cabezal AST2H o un combo Si utilizas una o varias pantallas, AST2C todo al válvulas de 30 vatios Astoria Custom. Nuestro objetivo con el Astoria Antes de continuar, asegúrate de que asegúrate de emplear un cable de Custom era simple: crear un amplificador de un solo canal que conjugara la artesanía...
FUNCIONES DEL PANEL DELANTERO FUNCIONES DEL PANEL DELANTERO (CONT.) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - CABEZAL 1. ENTRADAS HI (ALTO) Y LO (BAJO) overdrive, generada por el La mayoría de los amplificadores Nota técnica: Si el pedal está conectado, 6.
Page 19
FUNCIONES DEL PANEL DELANTERO (CONT.) FUNCIONES DEL PANEL DELANTERO (CONT.) Nota tonal 1: El control EDGE corta las Nota tonal 4: El volumen MASTER se Con el fin de prolongar la vida de las frecuencias altas entre el divisor de fase encuentra después del inversor de fase.
FUNCIONES DEL PANEL TRASERO FUNCIONES DEL PANEL TRASERO (CONT.) ASTORIA CUSTOM - COMBO ASTORIA CUSTOM - CABEZAL 1. ENTRADA DE LA RED ELÉCTRICA 2. HT FUSE 3. LT FUSE 4. LOUDSPEAKERS (ALTAVOCES) Conecta el cable de red (alimentación) a El fusible HT FUSE se quemará para El fusible LT FUSE se romperá...
Page 21
NOTAS Nota: El altavoz interno del combo 7. SEND (ENVIAR) AST2C es de 8 ohmios. El conector jack SEND conecta el previo a una entrada de efectos externa, o a un • 1 x 4 OHM, 2 x 8 OHM: Para conectar una sola pantalla de 4 ohmios o dos amplificador de potencia externo.
Page 31
Registered in England. Registered Number: 805676 Whilst the information contained herein is correct at the time of publication, due to its policy of constant improvement and development, Marshall Amplification plc reserves the right to alter specifications without prior notice. BOOK-00145-00...
Need help?
Do you have a question about the AST2C and is the answer not in the manual?
Questions and answers