Status Led Overview; For Ecdis Calibrated Products - Hatteland HD 12T04 SERIES User Manual

Status LED Overview

HOT KEY FUNCTION:
User can access input video/signal sources by DOUBLE clicking the navigator knob/button inwards. The cycle of the
video/signal detection are; Analog RGB1, Analog RGB2, DVI, Composite Video & S-Video. It will only switch to the
next detectable video/signals sources that are present (physically connected). The incoming signal will be identified
and displayed as clear text in the upper left corner of the display.
STATUS LED OVERVIEW
The display features a multi purpose indicator LED status ring which through different patterns and realtime activity
gives back the status of the signal detected, power on/off, calibration, menu activity and more. The LEDs are
multicolored which either illuminate green or red, based on the activity.
OFF (No power connected)
8 LED OFF
ON (Signal OK)
8 GREEN LED STATIC ON
OFF (Shutdown)
1 RED LED MOVEMENT doing 1 loop.

For ECDIS Calibrated Products

For the MMD/MMC products that are ECDIS calibrated from factory, the following LED pattern (Calibrated) indicates
that the backlight/brightness is at calibrated level. (Calibrated +) or (Calibrated -) means that the knob/brightness is
above or below the calibrated brightness level. Fine adjust the navigator knob either clockwise or
counter-clockwise until the pattern for (Calibrated) is reached.
ON (Calibrated)
4 GREEN LED STATIC ON
Operation
IND100064-13
OFF (Standby, power detected)
8 RED LED STATIC ON
ON (No Signal)
4 RED LED STATIC ON
ON (Calibrated +)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION
27
ON (Signal Search)
1 GREEN LED MOVEMENT looping.
ON (Menu Delay)
7 GREEN LED STATIC +
1 LED OFF MOVEMENT doing 1 loop.
ON (Calibrated -)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION