Table of Contents
Advertisement
General Installation Recommendations
Panel cut-out mounting precaution
If you intend to mount the -Bxxx (bracket / stand-alone) model into a
precut panel, make sure you have read and understood the following
section. The Series 2 frameless design means that the front glass
reaches all the way to the outer rims of the unit.
Further, between the product chassis and the backside of the glass
there is a small gap which is filled with a gasket. This little gap is
subject of beeing "hooked" into the cut-out area edge if it is really
tight and you mount the product hasty. Also, if your panel cut-out
have small deviations you can accidentally break the glass edges.
Try to slide the unit gently straight forward and avoid skewing the unit. Do not force the unit into place. If you find
yourself in this position and notice that the back of the glass edge is forced forward by the panel cut-out
edges or you suspect a pressure building up, remove the unit, carefully modify the panel cut-out and check the
dimensions again. The unit can not be adjusted / modified in any way. The modifcation/adjustment has to be
performed on the cut-out. The mounting bracket HD 12TBR CMB-A1 is suitable for flush console mounting.
1: Start sliding the unit into the cut-out area
Flange model installation
The Flange Kit comes in 3 parts for each corner of the model (to be mounted at TOP and BOTTOM). The kit consists
of 4 x Flange Clips, 4 x mounting screws and 4 x panel mounting screws. Also, please review the PANEL MOUNTING
drawings in this manual for further illustrations.
1: Unscrew 4 screws from the chassis at
top and bottom of unit. These screws are no
longer needed.
Warning: Do not unscrew left and right screws.
Installation
IND100078-12
2: Continue to slide, while checking the corners 3: Glass edge now aligned. Fasten the unit.
2: Place Clips and secure it with the Flange
Clip Screws M4x8mm at top and bottom.
Warning: Using longer screw can result in
instant internal damage to the unit.
17
3: Place model into cut out and secure unit from
behind using the M6x25mm Screws.
Warning: Avoid using excessive force to fasten
these screws. Damage may occur over time.
Advertisement
Table of Contents
