Hatteland HD 12T04 SERIES User Manual page 24

Series 2 - display and computer backpack range
Hide thumbs Also See for HD 12T04 SERIES:
Table of Contents

Advertisement

Physical Connections - Series 2 MMC Backpack
A 9PIN D-SUB Female connector that supports RS232/422/485 (all optically isolated). Initially by factory default
this has set to operate in RS232 mode. Via software (MMC2 Utility*), COM1 can be configured to operate in either
RS422 or RS485 as well.
*Note: The "MMC2 Utility" software is preinstalled by factory default. You will find the icon on the operating system
start menu. For usage, please read the chapter: "HATTELAND® MMC2 Utility - Series 2" in this manual.
This is only an internal serial port and is indentified in the operating system as "COM2". This will allow you to
control brightness and retrieve various parameters, as well as configuring the communication mode for COM1
(RS232/422/485). For in-depth information, manual is available on this link:
http://www.hatteland-display.com/pdflink/inb100018-2.php
CompactFlash Reader supports Type I & II cards. Insert the card gently into the slot with the logo facing upwards (only
when the unit is OFF). The card is removed by pressing the EJECT button next to the card slot. A wide range of card
sizes are supported. The compact flash will be recognised as Primary IDE SLAVE. The selection of MASTER / SLAVE
setting for the compact flash is jumper configurable.
NOTE: DO NOT ATTEMPT TO REMOVE THE FLASH CARD WHILE THE UNIT IS OPERATING! This is because
the CF Slot has been configured to operate as a IDE device. If the Flash Card is removed from the slot while
the unit is on, data may be lost or partly corrupted.
The internal AC power module supports both 115VAC & 230VAC - 50/60Hz power input. You may secure the
connector further by using the clamp mounted on the connector base.
Secure the cables (check polarity on your model, marked on the label) to the screw terminal. The internal DC power
module supports 24 VDC nominal (18-36VDC).
Operation
IND100133-18
COM1:
COM2 SERIAL CONTROL INTERFACE:
CompactFlash Reader: (Not plug & play)
POWER INPUT: (AC Version)
POWER INPUT: (DC Version)
24

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hd 15t06seriesHt mmc0* a0 seriesHd 19t03 series

Table of Contents