Master audio DSP306USB User Manual page 17

Master Audio
frequency and slope have to be configured manually in the Xover Menu in each
Output menu.
Note: The configuration mode configures the input sources when selected. The user
can change the source afterwards if desired. It does not keep the configuration in
memory.
6.3.4.Copy - Copy channels
Copy Channels from the source to the target. When the Source and Targets are both
Inputs and Outputs, all audio parameters will be copied. When one of the Source or
the Target is an input while the other is an output, only the Level, Polarity, Delay and
EQ are copied.
• SOURCE - Channel to be copied from.
SYSTEM
SOURCE:In1
• TARGET - Channel to be copied to.
SYSTEM
TARGET:In2
6.3.5.General - General system parameters
• FREQ MODE - Selects the frequency control mode for EQ and crossover filters.
Can be 36 steps/octave or All Frequencies (1 Hz resolution).
SYSTEM
FREQ MODE:36/Oct
• DELAY UNIT - ms, ft or m.
SYSTEM
DELAY UNIT:ms
6.3.6.Comm – Communication Settings
• BAUD RATE – Sets the baud rate of serial communication. Default is 115200bps.
SYSTEM
BAUD RATE:115200
DSPSeries - MUS - Ver 1.1 ENG
Copy
Copy
Generl
Generl
Comm
Nov 10 17