4. Insert the new slim optical drive into the kit until you hear a click. The slim optical drive is secured in
place.
Figure 38. Installing the slim optical drive into the kit
3.5-inch internal storage drive
To install or replace a 3.5-inch internal storage drive in the kit, do the following:
1. Slide the kit out of the chassis. See "Optical drive" on page 66.
2. Press the clip as shown to open the rear cover of the kit.
Figure 39. Opening the kit from the rear
3. If you are replacing an old 3.5-inch internal storage drive, do the following:
.
Chapter 7
Hardware installation and replacement
73