Table of Contents
Advertisement
6. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Figure 24. Installing a memory module
7. Reinstall the PCIe x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 97.
Optical drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
Note: For some computer models, the optical-drive bay might be installed with an optical drive, a Multi-drive
Conversion Kit, or a Slim Optical Drive Adapter.
To install or replace an optical drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 55.
2. Remove the front bezel. See "Front bezel" on page 57.
3. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing an optical drive, do the following:
a. Remove the metal static shield from the desired drive bay.
66
P320 User Guide
2
in the slot. Push the memory module straight down into the slot until
1
on the memory
Hide quick links:
Advertisement
Table of Contents
