Rear Fan Assembly - Lenovo THINKSTATION P320 30BG User Manual

4. The front fan assembly is attached to the chassis by four rubber mounts. Remove the front fan assembly
by breaking or cutting the rubber mounts and gently pulling the front fan assembly out of the chassis.
Note: The new front fan assembly comes with four new rubber mounts attached.
Figure 75. Removing the front fan assembly
5. Install the new front fan assembly by aligning the new rubber mounts with the corresponding holes in
the chassis and push the rubber mounts through the holes.
6. Pull the tips of the rubber mounts until the front fan assembly is secured in place.
Figure 76. Installing the front fan assembly
7. Connect the front fan assembly cable to the power fan connector on the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 97.

Rear fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
To replace the rear fan assembly, do the following:
.
Chapter 7 Hardware installation and replacement
95