Table of Contents
Advertisement
Installing the solid-state drive
To install the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 55.
2. Install the solid-state drive into the storage converter shipped with the solid-state drive. Then install the
four screws to secure the solid-state drive to the storage converter.
Figure 69. Installing the solid-state drive into the storage converter
3. Remove the 3.5-inch storage drive bracket out of the chassis.
4. To install the storage converter into the 3.5-inch storage drive bracket, flex the bracket and align pin
pin
2
, pin
3
, and pin
4
on the bracket with the corresponding holes in the storage converter.
.
Chapter 7
Hardware installation and replacement
1
,
91
Hide quick links:
Advertisement
Table of Contents
