6. To install a new hard disk drive into the bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
5
board
on the bottom of the hard disk drive.
Figure 67. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 68. Installing the secondary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 97.
Solid-state drive
The solid-state drive is only available on some models.
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
90
P320 User Guide
1
, pin
2
, pin
3
, and