Instructions For Use - Varian MiniVac 929-0190 Instruction Manual

GENERAL INFORMATION
This equipment is destined for use by professionals.
The user should read this instruction manual and any
other additional information supplied by Varian before
operating the equipment. Varian will not be held
responsible for any events occurring due to non-
compliance, even partial, with these instructions,
improper use by untrained persons, non-authorised
interference with the equipment or any action contrary
to that provided for by specific national standards. The
MiniVac is a high voltage and low power feeder used to
feed the ionic pumps.
The following paragraphs contain all the information
necessary to guarantee the safety of the operator when
using the equipment. Detailed information is supplied in
the section "Technical Information".
This manual uses the following standard protocol:
!
The warning messages are for attracting the attention
of the operator to a particular procedure or practice
which, if not followed correctly, could lead to serious
injury.
The caution messages
procedures which, if not followed, could cause damage
to the equipment.
The notes contain important information taken from the
text.
STORAGE
When transporting and storing the MiniVacs, the
following environmental
satisfied:
•
temperature: from -20 °C to + 70 °C
•
relative humidity: 0 - 95%
(without condensation)
WARNING!
CAUTION!
are displayed before
NOTE
requirements should
PREPARATION FOR INSTALLATION
The controller is supplied in a special protective
packing. If this shows signs of damage which may have
occurred during transport, contact your local sales
office. When unpacking, ensure that the module is not
dropped or subjected to any form of impact. Do not
dispose of the packing materials in an unauthorised
manner. The material is 100% recyclable and complies
with EEC Directive 85/399.
be
Each controller is factory set for a specific power
supply:
•
Model 929-0190 KINGS type High voltage
connector (120 Vac, 50 – 60 Hz)
•
Model 929-0191 FISCHER type High voltage
connector (120 Vac, 50 – 60 Hz)
•
Model 929-0290 FISCHER type High voltage
connector (220 Vac, 50 – 60 Hz)
•
Model 929-0291 KINGS type High voltage
connector (220 Vac, 50 – 60 Hz)
10

INSTRUCTIONS FOR USE

Controller Packing
87-900-049-01 (E)