Cooling Fan Assembly Replacement - IBM 6150 Hardware Maintenance Manual

Cooling Fan Assembly Replacement
1. Connect the fan power connector at drive position C. Be sure to
connect drive C also.
2. Insert the right end of the cooling fan assembly onto the front cage, then
slide the fan bracket to the left behind the rear cage until the alignment
holes, between the two screw slots, align.
3. Tighten the two mounting screws.
Note: Be sure the cooling fan assembly is mounted as shown and that
the cables are routed properly. If needed, see Section 5.
4. Do the "Side Cover Replacement" on page 4-15.
Drive Position C
Mounting Screws
Removal and Replacement 4-51