IBM 6150 Hardware Maintenance Manual page 185

TNL SN32-9004 (August 87) to 75X0152 or 75X0166
Step 25
1. Look at the type and slot positions you recorded, and install the
boards and adapters you removed.
2. Unplug the external power cable from the outlet.
3. If needed, see Section 4 to install the covers.
4. Set the power switch on the system unit to On.
5. Follow the instructions on the menus to run the System Checkout.
The TEST OPTION and the DIAGNOSTIC TEST LIST menu will
display if the configuration was changed. Follow the instructions as
they display. If needed, see page 2-17.
WERE YOU ABLE TO LOAD AND RUN THE "SYSTEM
CHECKOUT" AND DID THE "NO TROUBLE WAS FOUND"
MESSAGE DISPLAY?
NO If the same failure occurs, contact your service support person,
otherwise, go to "Problem Determination Procedure PIC 0030"
on page 3-0030-1.
YES This completes the repair.
3-0060-26 Service Manual