Enervista Sr3 Setup Software Structure - GE 350 Communications Manual

CHAPTER 4: SR3 IEC61850 GOOSE

EnerVista SR3 Setup software structure

350 FEEDER PROTECTION SYSTEM – COMMUNICATIONS GUIDE
The 350 firmware accepts GOOSE messages from UR, F650 and UR Plus. The
interoperability with other manufacturers will be guaranteed in almost all cases, by
implementing the reception side with nested structures (one level of nesting) and all the
standard data types.
GOOSE settings changes will take effect only after the 350 relay is re-booted. One setting is
available to Enable/Disable both Transmission and Reception. It is possible to change this
setting from the Front Panel of the relay.
Figure 4-1: EnerVista SR3 GOOSE General Settings
The structure below reflects how the EnerVista SR3 Setup software should be used to
implement the sections detailed in this document, in order to enable both transmission
and reception of GOOSE messages.
SR3 IEC 61850 GOOSE DETAILS
4–37