Advertisement
S
1: C
T
S
TEP
OLLECT
OOLS AND
ETUP
R
EQUIREMENTS
•
No. 2 Phillips screwdriver and T10 Torx driver for the mounting
bracket screws
•
A standard USA- or EU-style single-gang wall outlet box
•
One of the following:
•
Customer-supplied IEEE 802.3af/at-compliant PoE switch
and customer-supplied Ethernet cable
•
Customer-supplied IEEE 802.3af/at-compliant PoE
injector and customer-supplied Ethernet cable
•
Customer-ordered DC power adapter (Ruckus part
number 902-0170-XX10, sold separately)
•
An Ethernet cable with or without PoE run through the wall
from your LAN through the wall outlet box
•
(optional) One or two separate Ethernet bypass cables run
through the outlet box
•
A computer with an Ethernet port and a wireless card
•
One Cat 5e or better Ethernet cable
Copyright © 2014 Ruckus Wireless, Inc.
Draft Published 11 December 2014, Part Number 800-70718-001 Rev A
S
2: C
C
TEP
ONNECT THE
OMPUTER TO THE
Figure 1: Top view
1
After removing your H500 from its package, place it next to
your computer.
2
Using an Ethernet cable, connect your computer's network
port to the PoE In port on the back of the H500.
3
Using an AC adapter (sold separately), connect the H500
12VDC port to a protected power source.
Alternatively, connect the PoE port to a PoE injector or switch
for both power and network connections.
4
Verify that the Power LED on the external enclosure is a steady
green.
Figure 2: Back view
PoE In Port
12VDC Port
H500
S
3: P
TEP
REPARE
S
ETUP
Note: The following procedures assume Windows 7 as the
operating system. Procedures for other OS's are similar.
1
On your Windows 7 computer, configure your network
adapter from the Local Area Connection settings as follows:
•
Start > Control Panel > Network and Sharing
Center > Change Adapter Settings
2
Edit the TCP/IPv4 address settings as follows:
•
Local Area Connection > Properties > Internet
Protocol Version 4 (TCP/IPv4) > Properties
The
TCP/IPv4 Properties
Important! Write down all of the currently active settings so you
can restore your computer to its current configuration later
(when this process is complete).
3
Select Use the following IP address (if it is not already
selected) and then make the following entries:
•
IP address: 192.168.0.22 (or any address in the
192.168.0.x network, except 192.168.0.1)
•
Subnet mask: 255.255.255.0
•
Default gateway: 192.168.0.1
Leave the DNS server fields empty.
4
Click OK to save your changes.
Your changes are put into effect immediately.
Y
C
H500
OUR
OMPUTER FOR
dialog box appears.
Page 2 of 4
Advertisement
