Festool KS 60 E Original Operating Manual page 20

KS 60 E
GB
4 Technical data
Sliding compound mitre
saw
Power
Power supply
No-load speed
1
Max. speed
Max. mitre angle
Max. inclination angle
Saw blade dimensions
Weight
Safety class
1.
Max. speed in the event of faulty electronics.
5 Machine features
[1-1] Handle
[1-2] Safety button
[1-3] On/Off switch
[1-4] Lever for groove depth limit
[1-5] Rotary knob for slide locking device
[1-6] Lever for transport locking device
[1-7] Spindle stop
[1-8] Stop ruler (both sides)
[1-9] Rotary knobs for securing the table exten-
sion (both sides)
[1-10] Angle display for mitre cuts
[1-11] Lever for locking the mitre angle
[1-12] Rotary base
[1-13] Pendulum guard
[2-1] Cable clamp
[2-2] Extractor connector
[2-3] On/off switch for spotlight (available as an
accessory depending on the model)
[2-4] FSZ120 fastening screw clamp
[2-5] Adjusting wheel for setting the speed
[2-6] Rotary knob for securing the rotary base
[2-7] Table extension (both sides)
[2-8] Bevel holder for clamping the bevel
[2-9] Star handle for securing the inclination
angle
[2-10] Key storage box for the Allen key
[2-11] Cable winder with integral carry handle
[3] Remove the transport safety device
20
KS 60 E
1200 W
220-240 V~ 50/60 Hz
1300 - 3500 rpm
5000 rpm
60° left/right
47/46° left/right
216 x 2,3 x 30 mm
17,8 kg
/II
[4] Insulated gripping surfaces (grey shaded
area)
6 Commissioning
6.1 Initial operation
WARNING
Unauthorised voltage or frequency!
Risk of accidents

Observe the specifications on the machine's
name plate.

Observe country-specific regulations.
Ensure that the power tool is securely posi-
tioned. Risk of tipping over. If required, ob-
serve the assembly instructions for the MFT
multifunction table or base frame UG-KAPEX
KS 60.

Remove the transport safety device [3].

Remove the protective sleeve from the left-
hand pulling rail

Push the saw unit down, thus breaking
through the cable ties that are securing it in
2
place .

Remove the clamp from around the tilt lock-
3
ing device .

Set up the machine and move it into the working
position.
6.2 Setting up and securing [5]
Pull out the mains plug before you carry out
any work on the machine.
Before securing, if required, install the A-SYS-KS60
support legs (optional accessory). Thanks to these
support legs, the work surface on the rotary base is
at the same height as a Systainer 1. These Systain-
ers mean that long workpieces can then be sup-
ported [5].
You have the following options for securing:
Secure the machine in such a way that it can-
not move when you are working on it.
Screws[5A]: Use four screws to secure the ma-
chine to the work surface. Use the holes [5A-1] at
the four support points on the saw table to do this.
Clamps[5B]: Use clamps [5B-1] to secure the ma-
chine to the work surface. The support points are
used to reliably secure the machine while taking
the centre of gravity into consideration.
.