Installation; Connecting The Antennas; Installation Requirements - Handlink Technologies WG-500P User Manual

WG‐500P Hotspot in a Printer
2­1 Connecting the Antennas
The WG‐500P provides two antenna connectors on the rear of the unit.
2­2 Installation Requirements
Before installing the WG‐500P, make sure your network meets the following
requirements.
System Requirements
The WG‐500P requires one of the following types of software:
Windows 98 Second Edition/NT/2000/XP/Vista
Red Hat Linux 7.3 or later version
MAC OS X 10.2.4 or later version
Any TCP/IP‐enabled systems like Mac OS and UNIX (TCP/IP protocol
installed)
Standard phone line for xDSL modem Or Coaxial cable for Cable modem
Web Browser Software (Microsoft I.E 5.0 or later version or Netscape
Navigator 5.0 or later version)
One computer with an installed 10Mbps, 100Mbps or 10/100Mbps Ethernet
card
UTP network Cable with a RJ‐45 connection (Package contents)
Note: Prepare twisted‐pair cables with RJ‐45 plugs. Use Cat.5 cable for all
connections. Make sure each cable not exceed 328 feet (Approximately 100 meters).
ISP Requirements
Verify whether your ISP use fixed or dynamic IP. If it is a fixed IP, be sure to get the IP
from your ISP. For dynamic IP, which is mostly used, the PC will get the IP
automatically whenever it hooks up on the modem.
2 Installation
14