Installation; Wall-Mounting - Handlink Technologies WG-602 User Manual

The followings are instructions for setting up the Wireless Subscriber Gateway. Refer to the illustration
and follow the simple steps below to quickly install your Wireless Subscriber Gateway.
2-1

Wall-Mounting

The Wireless Subscriber Gateway can be wall-mounted on a wall by applying the two mounting
brackets on screws.
Figure 2-1 Wall-Mounting Bracket - Bottom of Wireless Subscriber Gateway
Please refer to the following instructions for mounting a Wireless Subscriber Gateway on a wall or other
surface.
1. Install two screws on a wall according to the relative positions shown below.
2. Hang Wireless Subscriber Gateway on the wall by sliding the two screws in the mounting brackets.
Note: If the screws are not properly anchored, the strain of the cables connected to the Wireless
Subscriber Gateway rear panel connectors could pull out the Wireless Subscriber Gateway from
the wall.
12

2. Installation

Figure 2-2
Easy Hotspot Kit