Ethernet Introduction - Casio QT-7300 Service Manual

4-17. ETHERNET INTRODUCTION

4-17-1. Introduction
The QT-7300 is equipped with high performance Plug & Play Ethernet interface which is fully compliant with
IEEE802.3 standard, and consisting of RJ-45 connector .
4-17-2. Network Driver Installation under Windows98 Second Edition
This describes in detail the important steps when installing the SBC8360-4M network drivers under Win98SE.
IMPORTANT: During Win98SE installation, do not attempt to install your Sound Card & Network Adapter
hardware outright; doing so will install the older version of the device drivers within the Win98SE
setup program.
After completing the Win98SE installation, user must do the following action upon first-time entry into Win98SE:
1. Launch the Control Panel window
• Select the Start button at the bottom left corner of the screen then click on Settings.
• Choose Control Panel from the left and the following window appears on your display.
2. Access the System Properties window
• Double -click on System icon and then choose Device Manager from the menu.
• A new window will pop-up with Other Device represented by a "?" mark. Click this "?" mark and one
device marked with "?" appears on its subset device list. One device specifies the PCI Ethernet
Controller.
3. Enter the PCI Ethernet Controller Properties window
• Move the cursor to the PCI Ethernet Controller then double-click your left mouse button. The screen
then display the PCI Ethernet Controller Properties window.
4. Detect and specify the .INF network device driver path
• Click on Driver from the menu bar and a new screen appears with the Update Driver... button.
• Click on the this Update Driver... button and the Update Device Driver Wizard window appears.
Choose "Display a list of all drivers... " then click on the Next> button to proceed.
• Insert the EtherNet RTL8139 Disk II diskette (Disk ) into Drive A: and clock on Have Disk.
5. Capping the installation
• Enter the appropriate drive for your disk media (A:win98), and click on OK
• Click on OK ata the select Device dialog box.
• The Update Wizard display the message that it has found the driver. Click on Next> .
• Click on the Finish button to complete the installation of the PCI Ethernet Controller.
6. Provide Network Information
• Right after completing the network adapter installation, the system displays the network window
requiring you to fill up your computer's name, the workgroup it will appear in, and a short description
of it. Refer to the following screen.
• After filling up the items, press the Close button to exit.
7. Reboot the system
• Your system will now ask you whether you'd like to reset the computer. Click on the Yes button.
Note: We highly recommend that you reset the system in order for the new network driver to take
effect.
— 31 —