Touch Screen - Casio QT-7300 Service Manual

4-16. Touch screen

The QT-7300 is equipped with a quick-response touch screen that enables keyboard-less operation. To use the
touch screen, a related application program needs to be installed. This chapter provides all of the information
to install and use the software of the Fujitsu touch screen systems for Windows98 SE and Windows 2000.
4-16-1. System Requirements
The Fujitsu touch screen system requires a serial interface. COM1 is assigned for the touch screen system in
the QT-7300 system.
4-16-2. Installation
This section describes the installation procedure for the Windows Driver Disk.
There are two steps to install the touch screen drivers into the QT-7300 system.
Step 1 : Driver installation
Step 2 : Calibration
4-16-2-1. Driver installation
The accompanying Windows Driver Disk contains the following software:
1) For Windows 98 SE
(1) Run the "setup.exe" (Touch Panel Windows 98 Driver disk) file.
(2) Select "Primary install".
(3) Click "OK" button.
(4) Port setting window should open. Default condition is as below.
COM1, I/O address = 0x3f8, IRQ = 4
In the case that you want to use the touch panel as it is, click "OK" button.
(5) Restart the system.
Attention:
1) In the case that you need to use dual touch panels for a dual display condition, please select
"Secondary install" at step (2) when you install the second touch panel in addition.
2) In the case that you need to use dual touch panels for a dual display condition, please select
"Primary and Secondary install" at step (2) when you install the second touch panel at the same
time.
2) For Windows 2000
(1) Run the "setup.exe" (Touch Panel Windows 2000 Driver disk) file.
(2) Click "OK" button.
(3) Click "OK" button.
(4) Restart the system.
— 29 —