Introduction; Water Base Fog Technology; Lsg Mark Ii Low Fog Technology; Warning - Ultratec G3000 Operator's Manual

Introduction

Water Base Fog Technology

Water base fog technology is achieved by pumping a glycol/water mixture through a heat exchanger. This will
vaporize the fluid as it passes through the hot unit. The vaporization of the fluids force the hot mixture through
the output nozzle. When mixed with ambient air, it forms an opaque aerosol (fog). The fog is made up of tiny
droplets that form around the small particles in the air. The suspended droplets refract the light, allowing the fog
to take on the color of the light illuminating it.

LSG Mark II Low Fog Technology

The patented LSG Mark II technology uses liquid CO2 to cool the fog, generating a consistent effect at sub zero
temperatures. This process enables you to produce large quantities of low lying fog on a continuous basis without
cue time limitations or the messy water residue associated with other technologies. The LSG Mark II is compact
and mobile facilitating most applications.
The unique partnering of a fog effect with liquid CO2 is cost effective while providing a longer lasting effect.
Designed to be utilized with the LSG Mark II, the Ultratec Special Effects genuine 'Molecular Fog Fluid' provides
a dry, thick, white effect with a consistent dissipation that eliminates any ambient hazing. The "LSG Mark II"
couples with the G3000, offering the most advanced controls and fog output available. The LSG Mark II consumes
approximately 8 lbs. of Liquid Carbon Dioxide per minute of operation at 350 PSI.
The system can be controlled via the standard digital remote control, DMX or show control. The DMX LSG Mark II
Interface allows the LSG Mark II & Fog Machine to be controlled on separate DMX channels. Standard equipment
includes 10" ducting sleeve to facilitate standard ducting in many configurations based on fog distribution
requirements.

Warning

Important Safety Instructions:

1. Do not touch, place hands or expose skin within 20" (50 cm) of the discharge nozzle.
2. Do not remove the outer case.
3. Persons suffering from asthma or allergenic sensitivity may experience irritation, discomfort or allergic
symptoms when exposed to fog effects.
4. Ensure that this unit is grounded at all times. Failure to do so may result in serious injury.
5. Use Ultratec Special Effects fluid ONLY.

Safety Precautions

1. Ensure that any operation of the machine is supervised by suitably trained and authorized personnel.
2. Do not modify the machine or use a machine which has been damaged in any way.
3. Allow sufficient air circulation around the machine at all times.
4. Protect the machine from direct weather effects and wet locations.
5. Only use fluids manufactured by Ultratec Special Effects.
6. Do not continue to produce fog when visibility is reduced to 20" 50cm or below.
7. Avoid directing fog output continuously at people, structures or objects within close proximity of the discharge
nozzle.
8. Ensure that adequate exhausting arrangements are available in the event of an emergency.
3
www.ultratecfx.com